Dark Mechanicus, but only half the story (Part 2)

Before JtD gets the works, I needed to make the bulk of the base (restricted to a 'Terminator Base' [40 mm] for this competition), for scale. Just needed a cog, so a little press-moulding was in order.

The Cog ...

In GW Green Stuff (for flexibility) ...

Voilà ...

ProCreate filled (paraffin wax-assisted, never waste any putty ;) ) ...

Voilà ...

Result is more than fine for this project. There was a little irrelevant tearing, as I took it out early, because of the complexity of the teeth etc.

The Base moves on ...